Posts with «h-shifter» label

A DIY H-shifter for driving simulators built from just two components

An H-pattern shifter for driving simulators can be built from just two basic electronic components. That is what Jason did, combining an analog joystick salvaged from a game controller with an Arduino Pro Micro. A 3D printer and ready-made firmware take care of the rest. This makes a DIY H-shifter a project within reach of anyone with a board in a drawer and a bit of filament.

The starting point is a joystick like the ones found inside many game controllers. Jason connects it to the Arduino Pro Micro with very simple wiring, so no shields, adapters or tricky soldering are needed. The two electronic components then go inside a 3D-printed prototype case, completed by a gear knob that reproduces the chosen H pattern. In practice, the mechanics of the shifter are all in the geometry of the knob and the case, while the electronics simply read the joystick’s movement.

The firmware and the shifter options

The firmware is already available and is loaded onto the board once everything is assembled. It is not a single fixed block: it offers many options for different shifter configurations, so it adapts to different patterns and behaviours without rewriting the code from scratch. For anyone wanting to rebuild the project, this is the part that saves the most time, because the work of reading the joystick and sending commands to the simulator is already done.

Anyone who wants to replicate the DIY H-shifter can start from just a few parts. The basic list is short:

  • an analog joystick like the ones in game controllers
  • an Arduino Pro Micro
  • 3D-printed case and knob
  • the ready-made firmware, to be loaded onto the board

If the joystick does not come from a discarded controller, there is a small analog resistive joystick that works on the same principle as the one used in the PSP1000. Instead of the Pro Micro you can also use an Arduino Micro, which carries the same ATmega32U4 and presents itself to the PC as a USB joystick or keyboard.

Case and knob: 3D printing makes the H pattern

The mechanical side is all in the 3D prints. The prototype case holds the joystick and the board together, while the gear knob implements the chosen H pattern. Changing the knob changes the gear layout, so the project adapts to different configurations without touching the electronics. The result is a very low-cost H-shifter prototype, intended for a simulated driving setup rather than for surviving hours of competition.

Anyone who wants to see how the project is made and where to start will find everything on the project page on Hackaday.io, where Jason collects the work on the shifter. There you can also see which options the firmware offers and how the assembly is organised.

The interesting thing is the ratio between effort and result. Two salvaged components, a 3D print and ready-made firmware are enough to have a working H-shifter. You do not need a fully equipped workbench, and you do not need dedicated encoders or sensors. For anyone who wants to get into driving simulation without immediately buying a commercial peripheral, this DIY H-shifter is a concrete starting point.

Source: https://hackaday.io/contests

Related products

The post A DIY H-shifter for driving simulators built from just two components appeared first on Open Electronics.